Turin Parco del Valentino Car Show. Pagani Huayra Full Carbon


A full carbon Huayra is always a pleasure to the eyes. This one with a Saudi Arabia plate was on show at the Salone dell' Automobile ar Parco del Valentino, Turin.

Please see also my YouTube channel: https://www.youtube.com/user/settime2588


The Huayra uses a twin-turbo, V12 engine developed by Mercedes-AMG specially for the Huayra. The Huayra's 6.0-litre engine, the M158, produces 730 HP and 1,100 N·m of torque. Its top speed is about 383 km/h.


The Pagani Huayra is different from its predecessor in that it incorporates active aerodynamics. It is capable of changing the height of the front from the ground and independently operating four flaps placed at the rear and front of the car. The behavior of the flaps is managed by a dedicated control unit that is fed information from systems such as the ABS and ECU, which pass on information about the car's speed, yaw rate, lateral acceleration, steering angle and throttle position. This is intended to achieve minimal drag coefficient or maximum downforce depending on the situation. 


The Huayra's designer Horacio Pagani states that it has a variable drag coefficient of between .31 to .37. The system also prevents excess body roll in the corners by raising the "inside" flaps (i.e. the left ones in a left-handed corner and vice versa), increasing the downforce on that side of the car. The rear flaps also act as an airbrake. Under hard braking, both the front suspension and the two rear flaps are raised to counteract weight transfer to the front wheels and keep the whole car stable, for instance when entering a corner. 



Air from the radiator is extracted through an arch in the bonnet at an angle that is designed not to affect the streamline around the body. The side air intakes behind the front wheels create a low pressure zone, resulting in downforce.

Comments

Popular posts from this blog

Milano Malpensa Airport. Designed by Ettore Sottsass. MXP

Cooking The Khachapuri from Georgia. Tried it in Warsaw